Duty Belt Locker Hanger
HANG IT ONCE.GEAR UP FAST.
Your belt off the shelf and on the locker door: two steps, no tools.
Setup
HOW IT HANGS
1
Insert in the vent
Push the top of the hanger into a vent on the locker door, flag side facing you. It sits flat against the door.
2
Hang your belt
Cobra® buckle: push the buckle up onto the tongue at the bottom until it clicks.
Any other buckle: hang it on one of the three hooks, or thread the belt through the slot.
3
Take it off
Squeeze both wings of the Cobra buckle at the same time and lift the belt off. A standard buckle just lifts off its hook.
Fit
FITS MOST BELTS
Sam Browne
Metal
Plastic
Polymer
Cobra®
Not made for 2″ Cop-Lok buckles. Check that your buckle fits before you load the belt.
Built for the job
THE SPECS
75 LBRated load
POLYMERHeavy-duty
NO TOOLSSlips into the vent
3 + 1Hooks plus a belt slot
In the package
THE CARD IN YOUR BAG
Quick answers
LOCKER HANGER FAQ
Most duty belts. Sam Browne, metal, plastic and polymer buckles hang on the hooks or go through the slot, and Cobra® buckles click onto the tongue. It is not made for 2″ Cop-Lok buckles.
It is rated to 75 lb, enough for a fully loaded duty belt.
No. The top slips into a vent on the locker door. No screws, no drilling, nothing to damage the locker.
Squeeze both brass wings at the same time, then lift. One wing on its own will not release it; that is how the buckle is designed.
Belts with a standard buckle hang by the buckle on a hook. The hooks also take keys, a lanyard or a hat.
Email [email protected] with a photo and we’ll sort it out.
Cobra® is a registered trademark of AustriAlpin GmbH. This product is not made, sponsored or endorsed by AustriAlpin.